Console House 10 Mode Instrukcje Operacyjne Pobierz pdf (Strona 100)

1, 2, 3, 4, 5, 6, 7, or 8, respectively. When you have entered the dial

order of your choice, press ' # '. Enter a single ' 0 ' if no dial out is

desired.

The default Dial Order for Area 1 is 1 2 3 4 5 6 7 8.

If using area arming, Area 2 has a separate dial order in which calls

are placed if an Alarm is activated in Area 2. The same numbers that

are called for Area 1 may also be called for Area 2.

The default Dial Order for Area 2 is 1 2 3 4 5 6 7 8.

To configure different arming and disarming options for each area,

from the Setup menu, press the 5 (ARM) key.

If area arming is being used, you are first prompted to specify the area

to configure:

AREA:

ENTER AREA

↓

Enter the area number followed by the ' # ' key, or use the arrow keys

to select the area from a list of areas.

You can then set up the following items for the specified area.

The Entry Delay is the time, in seconds, that you have to turn off the

alarm after entering your home. The entry delay only applies to the

entry/exit zone (i.e. your doors). If you (or someone else) come in

through a window, there will be no entry delay and the alarm will

sound immediately.

When you come in through a door on an entry/exit zone, the other

zones are delayed too. This allows you to get to your phone or console

to turn off the security system, even if you have to go through a room

protected by a motion detector.

Area 2 Dial Order

Set Up Arming

Entry Delay

1 2 ... 95 96 97 98 99 100 101 102 103 104 105 ... 135 136

Brak uwag

Console House 10 Mode Instrukcje Operacyjne Strona 100